DataSheet.jp

NSVS784 の電気的特性と機能

NSVS784のメーカーはNew Japan Radioです、この部品の機能は「JRC SAW FILTER」です。


製品の詳細 ( Datasheet PDF )

部品番号 NSVS784
部品説明 JRC SAW FILTER
メーカ New Japan Radio
ロゴ New Japan Radio ロゴ 




このページの下部にプレビューとNSVS784ダウンロード(pdfファイル)リンクがあります。
Total 4 pages

No Preview Available !

NSVS784 Datasheet, NSVS784 PDF,ピン配置, 機能
www.DataSheet4U.com
NSVS784 Dec-01
Application
GSM TX
JRC SAW FILTER
NSVS784
Electrical Specification: (Table 1)
The device characteristics are measured in the circuit shown in Fig.1.
Table 1. Electrical Specifications
Item
Spec.
Typical
Input and Output Impedance
- 50
Nominal Center Frequency (f0)
- 902.5MHz
Insertion Loss
890~915MHz
3.8dB max.
3.1dB
Response Variation
890~915MHz
1.5dB max.
0.8dB
Group Delay Variation 890~915MHz
2.5 max.
2.0
Out of Band Rejection
(Relative to
Through Level)
DC~870MHz
870~880MHz
925~935MHz
30dB min.
6dB min.
8dB min.
45dB
20dB
13dB
935~980MHz
25dB min.
33dB
980~1200MHz
45dB min.
60dB
1200~2000MHz
10dB min.
25dB
2000~3000MHz
8dB min.
17dB
(Operating Temperature Range: -30~+85ºC)
Maximum Rating: (Table 2)
Table2.Maximum Ratings
Item
Maximum Input Power
Maximum DC Voltage
Operating Temperature Range
Storage Temperature
Rating
+20dBm
7.5V
-30~+85ºC
-40~+95ºC
Mechanical Specifications: (Fig.2)
Package is designed as small as 3.0x3.0x1.15[mm3] for SMD (Surface Mount Device) type.
Notice:
This part is electrostatic discharge sensitive and may be damaged by improper handling.
Communications Equipment Division
Communications Equipment Marketing Department
17-22 Akasaka 2-chome minato-ku,
Tokyo. 107-0052 Japan
Tel. +81 3-3584-8811
Fax. +81 3-3584-8876
http://www.jrc.co.jp/product/comm/deveice/saw/saw_top.html (Japanese)
http://www.jrc.co.jp/product/comm/device/saw/saw_top_e.html (English)

1 Page





NSVS784 pdf, ピン配列
NSVS784 July 01
Notice
1. Use this component within operating temperature range. It might not be
satisfied with electrical specification without operating temperature range.
When it is used less than -30ºC or more than +85ºC, it might be a cause of
degradation or destruction of the component. Even if it endures during a short
time, it causes degradation of qualification.
2. When soldering iron is used, solder with the temperature at the tip of soldering
iron: 350ºC max., the time of soldering: 10 seconds max., the power of
soldering iron: 30W max..
3. Notice that the allowed time of soldering with soldering iron is accumulated
time, when soldering is repeated.
4. As rapid temperature change for cleaning after reflow soldering might be a
cause of destruction clean this component after confirming that temperature of
this component goes down to room temperature.
5. Confirm that there are not any influence for qualification to this component in
mounting on PCB when this component is cleaned.
6. As it might be a cause of degradation of destruction to apply static electricity to
this component, do not apply static electricity or excessive voltage while
assembling and measuring. And do not transport this component with bare
hand.
7. As it might be a cause of degradation or destruction to apply D.C. voltage
between each terminal, apply D.C. voltage 7.5V max. in actual circuit.
Note
1. This specification specifies the quality of this component as a single unit. Make
sure that this component is evaluated and confirmed against this specification
when it is mounted to your products.


3Pages





ページ 合計 : 4 ページ
 
PDF
ダウンロード
[ NSVS784 データシート.PDF ]


データシートを活用すると、その部品の主な機能と仕様を詳しく理解できます。 ピン構成、電気的特性、動作パラメータ、性能を確認してください。


共有リンク

Link :


部品番号部品説明メーカ
NSVS783

JRC SAW FILTER

New Japan Radio
New Japan Radio
NSVS784

JRC SAW FILTER

New Japan Radio
New Japan Radio


www.DataSheet.jp    |   2020   |  メール    |   最新    |   Sitemap