|
|
PDF STR-W6735 Data sheet ( Hoja de datos )
| Número de pieza | STR-W6735 | |
| Descripción | Quasi-Resonant Topology Primary Switching Regulators | |
| Fabricantes | Sanken | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de STR-W6735 (archivo pdf) en la parte inferior de esta página. Total 13 Páginas | ||
|
No Preview Available !
STR-W6735
Quasi-Resonant Topology
Primary Switching Regulators
Features and Benefits
▪ Quasi-resonant topology IC Low EMI noise and soft
switching
▪ Bottom-skip operation Improved system efficiency
over the entire output load by avoiding increase of
switching frequency
▪ Standby burst mode operation => Lowers input power at
very light output load condition
▪ Avalanche-guaranteed MOSFET Improves system-
level reliability and does not require VDSS derating
▪ 500 V / 0.57 Ω, 160 W (120 VAC input)
Continued on the next page…
Package: 6-pin TO-220
Description
The STR-W6735 is a quasi-resonant topology IC designed for
SMPS applications. It shows lower EMI noise characteristics
than conventional PWM solutions, especially at greater than
2 MHz. It also provides a soft-switching mode to turn on the
internal MOSFET at close to zero voltage (VDS bottom point)
by use of the resonant characteristic of primary inductance
and a resonant capacitor.
The package is a fully molded TO-220, which contains the
controller chip (MIC) and MOSFET, enabling output power up
to 160 W with a 120 VAC input. The bottom-skip function skips
the first bottom of VDS and turns on the MOSFET at the second
bottom point, to minimize an increase of operating frequency
at light output load, improving system-level efficiency over
the entire load range.
There are two standby functions available to reduce the input
power under very light load conditions.The first is an auto-burst
mode operation, that is internally triggered by periodic sensing,
and the other is a manual standby mode, which is executed
by clamping the secondary output. In general applications,
the manual standby mode reduces the input power further
compared to the auto-burst mode.
The soft-start mode minimizes surge voltage and reduces
power stress to the MOSFET and to the secondary rectifying
Continued on the next page…
Typical Application
D
1
4
STR-W6735
VCC
Controller
(MIC)
6
FB
37
S/GND OCP/BD
5
SS /OLP
ROCP
RX
CX
P S1
+B
ErrAmp A
D
S2
B SI
GND
Standby
ON/OFF
LowB
Standby
Out
GND
A For ErrAmp, Sanken SE series device recommended
B For SI, Sanken linear regulator IC recommended
28103.30-5
SANKEN ELECTRIC CO., LTD.
http://www.sanken-ele.co.jp/en/
1 page  
STR-W6735
Quasi-Resonant Topology
Primary Switching Regulators
ELECTRICAL CHARACTERISTICS
Characteristic
Symbol
Terminals
Min.
Typ.
ELECTRICAL CHARACTERISTICS for Controller (MIC)1, valid at TA = 25°C, VCC = 20 V, unless otherwise specified
Max.
Units
Power Supply Start-up Operation
Operation Start Voltage
Operation Stop Voltage
Circuit Current In Operation
Circuit Current In Non-Operation
Oscillation Frequency
Soft Start Operation Stop Voltage
Soft Start Operation Charging Current
VCC(ON)
VCC(OFF)
ICC(ON)
ICC(OFF)
fosc
VSSOLP(SS)
ISSOLP(SS)
4-3
4-3
4-3
4-3
1-3
5-3
5-3
16.3
8.8
–
–
19
1.1
–710
18.2
9.7
–
–
22
1.2
–550
19.9
10.6
6
100
25
1.4
–390
V
V
mA
μA
kHz
V
μA
Normal Operation
Bottom-Skip Operation Threshold Voltage 1
Bottom-Skip Operation Threshold Voltage 2
Overcurrent Detection Threshold Voltage
OCP/BDOCP/BD Terminal Outflow Current
Quasi-Resonant Operation Threshold Voltage 1
Quasi-Resonant Operation Threshold Voltage 2
FB Terminal Threshold Voltage
FB Terminal Inflow Current (Normal Operation)
VOCPBD(BS1)
VOCPBD(BS2)
VOCPBD(LIM)
IOCPBD
VOCPBD(TH1)
VOCPBD(TH2)
VFB(OFF)
IFB(ON)
7-3
7-3
7-3
7-3
7-3
7-3
6-3
6-3
–0.720
–0.485
–0.995
–250
0.28
0.67
1.32
600
–0.665
–0.435
–0.940
–100
0.40
0.80
1.45
1000
–0.605
–0.385
–0.895
–40
0.52
0.93
1.58
1400
V
V
V
μA
V
V
V
μA
Standby Operation
Standby Operation Start Voltage
Standby Operation Start Voltage Interval
Standby Non-Operation Circuit Current
FB Terminal Inflow Current, Standby Operation
FB Terminal Threshold Voltage, Standby Operation
Minimum On Time
Maximum On Time
VCC(S)
VCC(SK)
ICC(S)
IFB(S)
VFB(S)
tON(MIN)
tON(MAX)
4-3
4-3
4-3
6-3
6-3
1-3
1-3
10.3 11.1 12.7
1.10 1.35 1.75
– 20 56
– 4 14
0.55 1.10 1.50
– 0.75 1.20
27.5 32.5 39.0
V
V
μA
μA
V
μs
μs
Protection Operation
Overload Protection Operation Threshold Voltage
VSSOLP(OLP)
5-3
Overload Protection Operation Charging Current
ISSOLP(OLP)
5-3
Overvoltage Protection Operation Voltage
VCC(OVP)
4-3
Latch Circuit Holding Current2
ICC(H)
4-3
Latch Circuit Release Voltage2
VCC(La.OFF)
4-3
ELECTRICAL CHARACTERISTICS for MOSFET, valid at TA = 25°C, unless otherwise specified
Drain-to-Source Breakdown Voltage
VDSS
1-3
Drain Leakage Current
IDSS
1-3
On Resistance
RDS(on)
1-3
Switching Time
tf 1 - 3
Thermal Resistance
RθCF
Channel to Internal
Frame
4.0
–16
25.5
–
6.0
500
–
–
–
–
4.9
–11
27.7
45
7.2
–
–
–
–
–
5.8 V
–6 μA
29.9 V
140 μA
8.5 V
–V
300 μA
0.57 Ω
400 ns
1.55 °C/W
1Current polarity with respect to the IC: positive current indicates current sink at the terminal named, negative current indicates source at the
terminal named.
2Latch circuit refers to operation during Overload Protection or Overvoltage Protection.
28103.30-5
SANKEN ELECTRIC CO., LTD.
5
5 Page 
STR-W6735
Quasi-Resonant Topology
Primary Switching Regulators
10.0 ±0.2
Gate Burr
PACKAGE DIMENSIONS, TO-220
4.2 ±0.2
2.8 ±0.2
Branding
XXXXXXXX
XXXXXXXX
1.34
+0.2
–0.1
1.74
+0.2
–0.1
6×P1.27 ±0.15 = 7.62 ±0.15
Terminal dimensions at case surface
0.45
+0.2
–0.1
2.6 ±0.1
Terminal dimension at case surface
5.08 ±0.6
Terminal dimension at lead tips
1234567
Gate burr: 0.3 mm (max.)
Terminal core material: Cu
Terminal treatment: Ni plating and solder dip
Heat sink material: Cu
Heat sink treatment: Ni plating
Leadform: 2003
Weight (approximate): 2.3 g
Dimensions in millimeters
Drawing for reference only
Branding codes (exact appearance at manufacturer discretion):
1st line, type: W6735
2nd line, lot: YMDD R
Where: Y is the last digit of the year of manufacture
M is the month (1 to 9, O, N, D)
DD is the 2-digit date
R is the manufacturer registration symbol
28103.30-5
SANKEN ELECTRIC CO., LTD.
11
11 Page | ||
| Páginas | Total 13 Páginas | |
| PDF Descargar | [ Datasheet STR-W6735.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| STR-W6734 | Power IC for Quasi-Resonant Type Switching Power Supply | Sanken |
| STR-W6735 | Quasi-Resonant Topology Primary Switching Regulators |  Allegro MicroSystems |
| STR-W6735 | Quasi-Resonant Topology Primary Switching Regulators | Sanken |
| STR-W6735N | Power IC for Quasi-Resonant Type Switching Power Supply | Sanken |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |