|
|
PDF GL650USB Data sheet ( Hoja de datos )
| Número de pieza | GL650USB | |
| Descripción | USB 4 PORT HUB CONTROLLER | |
| Fabricantes | ETC | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de GL650USB (archivo pdf) en la parte inferior de esta página. Total 16 Páginas | ||
|
No Preview Available !
Genesys Logic, Inc.
GL650USB
USB 4 PORT HUB CONTROLLER
DATA SHEET, Version 1.2
Aug. 18, 2000
Genesys Logic, Inc.
10F, No.11, Ln.3, Tsao Ti Wei, Shenkeng, Taipei, Taiwan
Tel: 886-2-2664-6655 Fax: 886-2-2664-5757
http://www.genesyslogic.com
1 page  
4 BLOCK DIAGRAM
GL650USB 4 PORT USB HUB CONTROLLER
UPSTREAM
PORT
D+ D-
TRANS-
CEIVER
HUB REPEATER
12 MHz
PLL
SIE
PORT CON-
TROLLER
TRANS-
CEIVER
PORT CON-
TROLLER
TRANS-
CEIVER
Registers
Micro-
Controller
ROM
RAM
D+ D-
LED
DOWNSTREAM
PORT 1
D+ D-
LED
DOWNSTREAM
PORT 4
5
08/18/00
Revision 1.2
5 Page 
GL650USB 4 PORT USB HUB CONTROLLER
GPIOD
(offset 0F, default = 0Fh)
R/W R/W R/W R/W R/W R/W R/W
GPIO3D/ GPIO2D/ GPIO1D/ GPIO0D/
LED4# LED3# LED2# LED1#
General purpose I/O pin status –
If GPIOXOE = 1 (X: 0 ~ 3), GPIOX is driven with the level of internal GPIOXD latch, which
is the same as corresponding GPIOXD bit. If GPIOXOE = 0, GPIOXD reflects the level of
GPIOX pin, which may be different from internal GPIOXD latch. The value written to GPIOD
will be stored in an internal latch, no matter what direction the GPIOX pins are in. Bits 3 to 0
have been pre-assigned specific functions for LED indicators. (active low).
REV
R/O
REV7
( offset 10, default = current revision )
R/O R/O R/O R/O R/O R/O
REV6
REV5
REV4
REV3
REV2
REV1
This register returns current silicon revision number of the HUB.
Current revision is 8’h11. (Revision 1.1)
R/O
REV0
DEVSTUS
( offset 11, default = 00h )
R/W R/W R/W R/W R/W R/W R/W R/W
HCONFIG DEVADR6 DEVADR5 DEVADR4 DEVADR3 DEVADR2 DEVADR1 DEVADR0
USB device status registers. Procedure to set the device address:
1. After USB reset, the device responds to default address 0, and hub configuration = 0.
2. USB host controller issues SET_ADDRESS request to the device. (INTRB asserted)
3. Micro-controller recognizes the request, then set DEVADR register with appropriate value.
4. Micro-controller prepares the status stage of SET_ADDRESS request by programming
TXCTL0 register.
5. When the hub configuration value is not equal zero, HCONFIG is set to one.
USB reset will clear this register.
6 MAXIMUM RATINGS
Maximum ratings are the extreme limits to which the GL650USB/GL650USB-A can be exposed without
permanently damaging it. The GL650USB/GL650USB-A contain circuitry to protect the inputs against
damage from high static voltages; however, do not apply voltages higher than those shown in the table.
Keep VIN and VOUT within the range GND ≤ (VIN or VOUT) ≤ VCC. Connect unused inputs to the appropriate
voltage level, either GND or VDD.
Symbol
TSTG
TOP
VCC
VIN
I
IMGND
IMVCC
VESD
Characteristic
Storage temperature
Operating temperature
Supply voltage
DC input voltage
Maximum current per pin excluding VDD and VSS
Maximum current out of GND
Maximum current out of VCC
Static discharge voltage
Value
-55 to +150
0 to +70
-0.5 to +7.0
-0.5 to +VDD + 0.5
25
100
100
>4000
Unit
°C
°C
V
V
mA
mA
mA
V
11
08/18/00
Revision 1.2
11 Page | ||
| Páginas | Total 16 Páginas | |
| PDF Descargar | [ Datasheet GL650USB.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| GL650USB | USB 4 PORT HUB CONTROLLER | ETC |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |