DataSheet.jp

GS-R4002 の電気的特性と機能

GS-R4002のメーカーはSTMicroelectronicsです、この部品の機能は「SMALL SIZE STEP-DOWN SWITCHING REGULATOR FAMILY」です。


製品の詳細 ( Datasheet PDF )

部品番号 GS-R4002
部品説明 SMALL SIZE STEP-DOWN SWITCHING REGULATOR FAMILY
メーカ STMicroelectronics
ロゴ STMicroelectronics ロゴ 




このページの下部にプレビューとGS-R4002ダウンロード(pdfファイル)リンクがあります。
Total 3 pages

No Preview Available !

GS-R4002 Datasheet, GS-R4002 PDF,ピン配置, 機能
GS-R400/2 Family
SMALL SIZE STEP-DOWN
SWITCHING REGULATOR FAMILY
FEATURES
MTBF in excess of 500,000 hours
4A max output current
40V max input voltage
4V max drop-out voltage
Soft start
Non-latching short circuit protection
Crow-bar output overvoltage protection
DESCRIPTION
The GS-R400/2 series is a family of small sized
high current, high voltage step-down switching
regulators.
The integral heatsink allows a large power handling
capability and it provides also an effective shielding
to minimize EMI.
SELECTION CHART
Type
Ordering
Number
GS-R405/2
GS-R412/2
GS-R415/2
GS-R424/2
GS-R400V/2
Output
Voltage
(V)
Input
Voltage
(V)
5.1 ± 2%
12.0 ± 4%
15.0 ± 4%
24.0 ± 4%
5.1 to 24
9 to 40
16 to 40
19 to 40
28 to 40
Vo+4 to 40
Output
Ripple
(mVpp)
25
50
65
100
25 to 100
Regulation
Line Load
(mV/V) (mV/A)
2 20
5 40
6 60
6 80
2 to 6 20 to 80
Efficiency
(%)
Notes
80
85
87
90
80 to 90
Fixed output voltage
"
"
"
Progr. output voltage
Note : Line regulation is measured at Iout=1A.
Load regulation is measured at Vin=Vo+8V and Iout=0.5 to 1.5A.
Case temperature must be kept below 85° C
ABSOLUTE MAXIMUM RATINGS
Symbol
Parameter
Vi
Io
Tstg
Tcop
DC Input Voltage
Output Current
Storage Temperature Range
Operating Case Temperature Range
Value
42
4
– 40 to +105
– 20 to +85
Unit
V
A
°C
°C
June 1994
1/3

1 Page





GS-R4002 pdf, ピン配列
GS-R400/2 FAMILY
USER NOTES
Input Voltage
The recommended operating maximum DC input
voltage is 40V inclusive of the ripple voltage.
Case Grounding
The module case is internally connected to pin 2
and pin 3.
The PCB area below the module can be used as an
effective sixth side shield against EMI.
Thermal Characteristics
The case-to-ambient thermal resistance of all the
GS-R400/2 modules is about 8°C/W. This produces
a 32°C temperature increase of the module surface
for 4W of internal power dissipation.
Depending on the ambient temperature and/or on
the power dissipation, an additional heatsink or
forced ventilation may be required.
Input Impedance
The module has an internal capacitor connected
between the input pins in order to assure PWM
stability. This capacitor cannot handle large values
of high frequency ripple current and it can be per-
manently damaged if the primary energy source
impedance is not adequate.
The use of an external low ESR, high ripple current
capacitor located as close the module as possible
is recommended.
Suitable capacitors should have a RMS current
capability of 2.5 ARMS with a working voltage of 50
VDC and an ESR of 0,1at 100kHz. When space
is a limitation a 22µF ceramic multilayer capacitor
must be connected to the module input pins.
Output Voltage Programming
The GS-R400V/2 output voltage is programmed by
using a resistor.
The resistor must be located very close the module
and the PCB layout must minimize injected noise.
The value of the resistor is calculated by using the
following formula:
Rv
=
2.67
Vo
1
k
5.1
Vo can be adjusted between 5.1 and 24V.
Module Protection
The modules are protected against occasional and
permanent short circuits of the output pins to
ground. During short circuit (when the output cur-
rent exceeds the maximum value) the output is
automatically disabled. After a fixed time the module
starts again in a soft mode. The cycle is repeated
until the short circuit condition is removed.
The module can be permanently damaged if the
case temperature exceeds 85° C
Power Derating Curve
Information furnished is believed to be accurate and reliable. However, SGS-THOMSON Microelectronics assumes no responsibility for the
consequences of use of such information nor for any infringement of patents or other rights of third parties which may result from its use. No
license is granted by implication or otherwise under any patent or patent rights of SGS-THOMSON Microelectronics. Specification mentioned
in this publication are subject to change without notice. This publication supersedes and replaces all information previously supplied.
SGS-THOMSON Microelectronics products are not authorized for use as critical components in life support devices or systems without express
written approval of SGS-THOMSON Microelectronics.
© 1994 SGS-THOMSON Microelectronics – All Rights Reserved
SGS-THOMSON Microelectronics GROUP OF COMPANIES
Australia - Brazil - China - France - Germany - Hong Kong - Italy - Japan - Korea - Malaysia - Malta - Morocco - The Netherlands -
Singapore - Spain - Sweden - Switzerland - Taiwan - Thailand - United Kingdom - U.S.A.
3/3


3Pages





ページ 合計 : 3 ページ
 
PDF
ダウンロード
[ GS-R4002 データシート.PDF ]


データシートを活用すると、その部品の主な機能と仕様を詳しく理解できます。 ピン構成、電気的特性、動作パラメータ、性能を確認してください。


共有リンク

Link :


部品番号部品説明メーカ
GS-R400

20W TO 140W STEP-DOWN SWITCHING REGULATOR FAMILY

STMicroelectronics
STMicroelectronics
GS-R4002

SMALL SIZE STEP-DOWN SWITCHING REGULATOR FAMILY

STMicroelectronics
STMicroelectronics
GS-R400V

20W TO 140W STEP-DOWN SWITCHING REGULATOR FAMILY

STMicroelectronics
STMicroelectronics
GS-R400V

SMALL SIZE STEP-DOWN SWITCHING REGULATOR FAMILY

STMicroelectronics
STMicroelectronics


www.DataSheet.jp    |   2020   |  メール    |   最新    |   Sitemap