DataSheet.jp

V23086-C1051-A502 の電気的特性と機能

V23086-C1051-A502のメーカーはTycoです、この部品の機能は「PCB Single Relays」です。


製品の詳細 ( Datasheet PDF )

部品番号 V23086-C1051-A502
部品説明 PCB Single Relays
メーカ Tyco
ロゴ Tyco ロゴ 




このページの下部にプレビューとV23086-C1051-A502ダウンロード(pdfファイル)リンクがあります。

Total 5 pages

No Preview Available !

V23086-C1051-A502 Datasheet, V23086-C1051-A502 PDF,ピン配置, 機能
Automotive Relays
PCB Single Relays
Micro Relay K (THT – THR)
n Small power relay
n Limiting continuous current 30A
n Low weight
n Low noise operation
n Wave (THT) and reflow (THR/pin-in-paste) solderable versions
Typical applications
Car alarm, door control, door lock, heated front/rear screen, immobilizer,
lamps front/rear/fog light, interior lights, seat control, sun roof, window
lifter, wiper control.
Contact Data
Typical applications
Contact arrangement
Rated voltage
Rated current
Limiting continuous current
23°C
85°C
Limiting making current
Limiting breaking current
Contact material
Min. recommended contact load
Initial voltage drop at 10A, typ./max.
Operate/release time
Electrical enduranc
cyclic temperature -40°C, +25°C, +85°C
form C contact (CO) at 14VDC
Resistive/inductive load
V23086-*1*01-A403
1 form C, 1 CO
12VDC
NO/NC
30/25A
30/25A
20/15A
40A1)
30A
motor reverse blocked,
25A, 0.77mH
>1x105 ops.
form A contact (NO) at 14VDC
resistive 20A
>3x105 ops.
Wiper load
V23086-*1*02-A803
1 form C, 1 CO
10VDC
NO/NC
30/25A
30/25A
20/15A
40A1)
30A
AgSnO2
1A at 5VDC3)
30/300mV
typ. 3/1.5ms4)
wiper,
25A make/5A break,
generator peak,
20A on NC,1mH
>1x106 ops.
Mechanical endurance
>5x106 ops.
086C/R1_fcw1b
Resistive/inductive load
V23086-*1*01-A402
1 form A, 1 NO
12VDC
30A
30A
20A
40A1)
30A
Lamp load5)
V23086-*1*51-A502
1 form A, 1 NO
12VDC
30A
30A
20A
100A2)
30A
resistive 20A
>3x105 ops.
lamp 100A inrush,
10A steady state
>1x105 ops.5)
Max. DC load breaking capacity
1) The values apply to a resistive or inductive load with suitable spark suppression and at
maximum 13.5VDC for 12VDC load voltages. For a load current duration of maximum
3s for a make/break ratio of 1:10.
2) Corresponds to the peak inrush current on initial actuation (cold filament).
3) See chapter Diagnostics of Relays in our Application Notes or consult the internet at
http://relays.te.com/appnotes/
4) Measured at nominal voltage without coil suppression unit. A low resistive suppression
device in parallel to the relay coil increases the release time and reducesthe lifetime
caused by increased erosion and/or higher risk of contact tack welding.
5) Be aware of using right polarity, see Terminal Assignment. Wrong polarity will reduce
endurance.
Load limit curve 1: arc extinguishes, during transit time (changeover contact).
Load limit curve 2: safe shutdown, no stationary arc (make contact).
Load limit curves measured with low inductive resistors verified for 1000 switching events.
10-2013, Rev. 1013
www.te.com
© 2011 Tyco Electronics Corporation,
a TE Connectivity Ltd. company.
Datasheets and product specification ac-
cording to IEC 61810-1 and to be used only
together with the ‘Definitions’ section.
Datasheets and product data is subject to the
terms of the disclaimer and all chapters of
the ‘Definitions’ section, available at
http://relays.te.com/definitions
Datasheets, product data, ‘Definitions’ sec-
tion, application notes and all specifications
are subject to change.
1
http://www.Datasheet4U.com

1 Page





V23086-C1051-A502 pdf, ピン配列
Terminal Assignment
Bottom view on solder pins
1 form A, 1 NO
4
51
2
86ets_ab
Automotive Relays
PCB Single Relays
Micro Relay K (THT – THR) (Continued)
1 form C, 1 CO
34
51
2
86etw_ab
1 form A, 1 NO (lamp load)
(+)
5
4 (–)
1
2
86ets_ab
Dimensions
Micro Relay K, THT version
12.0 ± 0.2
2.5 ± 0.2
0.6 ± 0.2
5.8 ± 0.1
A
12.9 ± 0.3
0.95 ± 0.2
Mounting Hole Layout
Bottom view on solder pins
C
B
8.5
7.5
0.5
1.72
34
51
5x
0.4
0.3
2
AB
A
5x
0.4
0.3
AC
A
TE86etw_an1
Remark: Positional tolerances according to DIN EN ISO 5458
TE86etw_se
*) Additional tin tops max. 1mm
*) Additional tin tops max. 1 mm
10-2013, Rev. 1013
www.te.com
© 2011 Tyco Electronics Corporation,
a TE Connectivity Ltd. company.
Datasheets and product specification ac-
cording to IEC 61810-1 and to be used only
together with the ‘Definitions’ section.
Datasheets and product data is subject to the
terms of the disclaimer and all chapters of
the ‘Definitions’ section, available at
http://relays.te.com/definitions
Datasheets, product data, ‘Definitions’ sec-
tion, application notes and all specifications
are subject to change.
3


3Pages





ページ 合計 : 5 ページ
 
PDF
ダウンロード
[ V23086-C1051-A502 データシート.PDF ]


データシートを活用すると、その部品の主な機能と仕様を詳しく理解できます。 ピン構成、電気的特性、動作パラメータ、性能を確認してください。


共有リンク

Link :


部品番号部品説明メーカ
V23086-C1051-A502

PCB Single Relays

Tyco
Tyco


www.DataSheet.jp    |   2020   |  メール    |   最新    |   Sitemap