DataSheet.jp

BT1611I の電気的特性と機能

BT1611IのメーカーはAudiovoxです、この部品の機能は「AM/FM/CD/MP3/WMA Receiver Manual」です。


製品の詳細 ( Datasheet PDF )

部品番号 BT1611I
部品説明 AM/FM/CD/MP3/WMA Receiver Manual
メーカ Audiovox
ロゴ Audiovox ロゴ 




このページの下部にプレビューとBT1611Iダウンロード(pdfファイル)リンクがあります。
Total 30 pages

No Preview Available !

BT1611I Datasheet, BT1611I PDF,ピン配置, 機能
BT1611i
Owner's Manual
BT1611I MP3/WMA RECEIVER
SUB
RECORD
BASS
INT
AM/FM/CD/MP3/WMA Receiver
with Bluetooth Technology
MENU
/
AUX IN
TUNE

1 Page





BT1611I pdf, ピン配列
BT1611i
INSTALLATION INSTRUCTIONS
This unit is designed for installation in cars,
trucks and vans with an existing radio opening.
In many cases, a special installation kit will be
required to mount the radio to the dashboard.
These kits are available at electronics supply
stores and car stereo specialty shops. Always
check the kit application before purchasing to
make sure the kit works with your vehicle.
Pre-installation
1. Disconnect Battery
Before you begin, always disconnect the battery
negative terminal.
2. Remove Transport Screws
MONO
EQ
CD1211 CD RECEIVER
SCAN
/
AUX IN
TUNE
Universal Installation Using
Mounting Sleeve
1. Remove the detachable front panel, if it is
attached to the chassis, by pushing the
“Release” button.
2. Slide the mounting sleeve off of the
chassis if it has not already been removed.
If it is locked into position, use the removal
keys (supplied) to disengage it. The
removal keys are depicted on page 5.
3. Check the dashboard opening size by
sliding the mounting sleeve into it. If the
opening is not large enough, carefully cut
or file as necessary until the sleeve easily
slides into the opening. Do not force the
sleeve into the opening or cause it to bend
or bow. Check that there will be sufficient
space behind the dashboard for the radio
chassis.
4. Locate the series of bend tabs along the
top, bottom and sides of the mounting
sleeve. With the sleeve fully inserted into
the dashboard opening, bend as many of
the tabs outward as necessary to firmly
secure the sleeve to the dashboard.
5. Place the radio in front of the dashboard
opening so the wiring can be brought
through the mounting sleeve.
MONO
EQ
CD1211 CD RECEIVER
SCAN
/
AUX IN
TUNE
6. Follow the wiring diagram carefully and
make certain all connections are secure
and insulated with crimp connectors or
electrical tape to ensure proper operation.
7. After completing the wiring connections,
attach the front panel and turn the unit on
to confirm operation (vehicle ignition
switch must be on). If the unit does not
operate, recheck all wiring until the
problem is corrected. Once proper
operation is achieved, turn the ignition
switch off and proceed with final mounting
of the chassis.
8. Carefully slide the radio into the mounting
sleeve, making sure it is right-side-up, until
it is fully seated and the spring clips lock it
into place.
3


3Pages


BT1611I 電子部品, 半導体
WIRING
1. Power Antenna (dark blue wire) - Connect
to the power antenna or an amplifier. If not
used, tape the bare end of wire.
2. Ground (black wire) - Connect to the
ground terminal or a clean, unpainted part
of the chassis.
3. Memory/Battery (yellow wire) - Connect to
the battery or to a 12 volt power source
that is always live. The radio will not work
if this wire is not connected.
4. Accessory/Ignition (red wire) - Connect to
the existing radio wire or radio fuse.
5. Left Front Speaker
6. Right Front Speaker
7. Left Rear Speaker
8. Right Rear Speaker
9. RCA Outputs to Amplifier
10. Auxiliary Input RCAs (yellow)
11. Antenna
12. Subwoofer Output (blue)
13. iPod/jLink connector - Use this 8-pin DIN
socket to connect your jLink iPod cable.
14. jLinkcable (iPod Cable)
NOTE: The amplifiers in this radio are only
designed for use with four speakers. Never
combine (bridge) outputs for use with two
speakers. Never ground negative speaker
leads to chassis ground. Failure to wire
exactly as shown may cause electrical
damage to the radio.
15A
11
12
BT1611i
9
Gray
10
+
13
White/Black (-)
5
White (+)
Gray/Black (-)
Gray (+)
6
Green/Black (-)
Violet/Black (-)
7
Green (+)
Violet (+)
6
iPod Gen5
8
iPod
iPod Mini iPod Nano
14

6 Page



ページ 合計 : 30 ページ
 
PDF
ダウンロード
[ BT1611I データシート.PDF ]


データシートを活用すると、その部品の主な機能と仕様を詳しく理解できます。 ピン構成、電気的特性、動作パラメータ、性能を確認してください。


共有リンク

Link :


部品番号部品説明メーカ
BT1611I

AM/FM/CD/MP3/WMA Receiver Manual

Audiovox
Audiovox


www.DataSheet.jp    |   2020   |  メール    |   最新    |   Sitemap