|
|
Número de pieza | NL8060BC31-47D | |
Descripción | Display Module | |
Fabricantes | NEC | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de NL8060BC31-47D (archivo pdf) en la parte inferior de esta página. Total 36 Páginas | ||
No Preview Available ! www.DataSheet.co.kr
TFT COLOR LCD MODULE
NL8060BC31-47D
31cm (12.1 Type)
SVGA
LVDS interface (1port)
PRELIMINARY DATA SHEET
DOD-PP-0830 (6th edition)
This PRELIMINARY DATA SHEET is updated
document from PRELIMINARY DATA SHEET
DOD-PP-0802(5).
All information is subject to change without notice.
Please confirm the sales representative before
starting to design your system.
Document Number: DOD-PP-0830 (6th edition)
Published date: July 2009 CP(N)
1 © NEC LCD Technologies, Ltd.
2008-2009 All rights reserved.
Datasheet pdf - http://www.DataSheet4U.net/
1 page www.DataSheet.co.kr
NL8060BC31-47D
2. GENERAL SPECIFICATIONS
Display area
246.0 (H) × 184.5 (V) mm
Diagonal size of display 31cm (12.1 inches)
Drive system
a-Si TFT active matrix
Display color
Pixel
16,777,216 colors (At 8-bit input, FRC terminal= High)
262,144 colors (At 6-bit input, FRC terminal= Low or Open)
800 (H) × 600 (V) pixels
Pixel arrangement
RGB (Red dot, Green dot, Blue dot) vertical stripe
Dot pitch
0.1025 (H) × 0.3075 (V) mm
Pixel pitch
0.3075 (H) × 0.3075 (V) mm
Module size
280.0 (W) × 210.0 (H) × 9.1 (D) mm (typ.)
Weight
600 g (typ.)
Contrast ratio
900:1 (typ.)
Viewing angle
At the contrast ratio ≥10:1
• Horizontal: Right side 80° (typ.), Left side 80° (typ.)
• Vertical: Up side 80° (typ.), Down side 80° (typ.)
Designed viewing direction
At DPS= Low or Open: Normal scan
• Viewing direction without image reversal: Up side (12 o'clock)
• Viewing direction with contrast peak: Down side (6 o'clock)
• Viewing angle with optimum grayscale (γ≒2.2): Normal axis
(perpendicular)
Polarizer surface
Antiglare
Polarizer pencil-hardness 3H (min.) [by JIS K5400]
Color gamut
Response time
Luminance
Signal system
At LCD panel center
40% (typ.) [against NTSC color space]
Ton+Toff (10%←→ 90%)
18 ms (typ.)
At IL= 50mA/One circuit
450 cd/m2 (typ.)
LVDS 1port
(Receiver: THC63LVDF84B, THine Electronics Inc. or equivalent)
[8bit/6bit digital signals for data of RGB colors, Dot clock (CLK),
Data enable (DE)]
Power supply voltage
LCD panel signal processing board: 3.3V
LED backlight type:
Backlight
Power consumption
Replaceable part
• Lamp holder set: Type No. 121LHS29
Recommended part (Option)
• LED driver board :Type No. 121PW01F
At IL=50mA/One circuit, Checkered flag pattern
(4.9) W (typ.)
6
6
PRELIMINARY DATA SHEET DOD-PP-0830 (6th edition)
5
Datasheet pdf - http://www.DataSheet4U.net/
5 Page www.DataSheet.co.kr
4.4 POWER SUPPLY VOLTAGE SEQUENCE
4.4.1 LCD panel signal processing board
VCC
Note1
0V
ON
3.0V
10μs ≤Tr< 50ms
Display signals*,
Function signals
Note2
0V
0ms <t< 35ms
VALID period
NL8060BC31-47D
OFF ON
0.3V
Toff≥ 50ms
0ms <t< 35ms
* These signals should be measured at the terminal of 100Ω resistance.
Note1: In terms of voltage variation (voltage drop) while VCC rising edge is below 3.0V, a protection
circuit may work, and then this product may not work.
Note2: Display signals (D0+/-, D1+/-, D2+/-, D3+/- and CLK+/-) and function signals (DPS, FRC
and MSL) must be Low or High-impedance, exclude the VALID period (See above sequence
diagram), in order to avoid that internal circuits is damaged.
If some of display and function signals of this product are cut while this product is working,
even if the signal input to it once again, it might not work normally. VCC should be cut when
the display and function signals are stopped.
4.4.2 LED driver board (Option)
Display signals,
Function signals
Note1
Note2
VALID period
6
LED backlight: ON
Note1: These are the display and function signals for LCD panel signal processing board.
Note2: The backlight should be turned on within the valid period of display and function signals, in
order to avoid unstable data display.
PRELIMINARY DATA SHEET DOD-PP-0830 (6th edition)
11
Datasheet pdf - http://www.DataSheet4U.net/
11 Page |
Páginas | Total 36 Páginas | |
PDF Descargar | [ Datasheet NL8060BC31-47D.PDF ] |
Número de pieza | Descripción | Fabricantes |
NL8060BC31-47 | TFT COLOR LCD MODULE | NEC |
NL8060BC31-47D | Display Module | NEC |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |