VCA2616 Datasheet PDF - Burr-Brown
| Part Number | VCA2616 | |
| Description | (VCA2611 / VCA2616) Variable-Gain Amplifier | |
| Manufacturers | Burr-Brown | |
| Logo |  |
|
|
There is a preview and VCA2616 download ( pdf file ) link at the bottom of this page. Total 19 Pages | ||
Preview 1 page No Preview Available !
www.datasheet4u.com
VCA2616VCA2616
VCA2611
SBOS234E – MARCH 2002 – REVISED NOVEMBER 2004
Dual, Variable-Gain Amplifier
with Low-Noise Preamp
FEATURES
q LOW-NOISE PREAMP:
– Low Input Noise: 0.95nV/√Hz
– Active Termination Noise Reduction
– Switchable Termination Value
– 80MHz Bandwidth
– 5dB to 25dB Gain
– Differential In and Out
q LOW-NOISE VARIABLE GAIN AMPLIFIER:
– Low-Noise VCA
– Up to 40dB Gain Range
– 40MHz Bandwidth
– Differential In and Out
q LOW CROSSTALK: 66dB at Max Gain, 5MHz
q HIGH-SPEED VARIABLE GAIN ADJUST
q SWITCHABLE EXTERNAL PROCESSING
APPLICATIONS
q ULTRASOUND SYSTEMS
q WIRELESS RECEIVERS
q TEST EQUIPMENT
FBCNTL
LNPOUTN VCAINN VCACNTL
RF2 FBSW
RF1 FB
VCA2616
(1 of 2 Channels)
Analog
Control
Maximum Gain Select
MGS1 MGS2 MGS3
Maximum Gain
Select
DESCRIPTION
The VCA2616 and VCA2611 are dual, Low-Noise Preamplifiers
(LNP), plus low-noise Variable Gain Amplifiers (VGA). The
VCA2611 is an upgraded version of the VCA2616. The only
difference between the VCA2616 and the VCA2611 is the input
structure to the LNP. The VCA2616 is limited to –0.3V negative-
going input spikes; the VCA2611 is limited to –2.0V negative-
going input spikes. This change allows the user to use slower
and less expensive input clamping diodes prior to the LNP input.
In some designs, input clamping may not be required.
The combination of Active Termination (AT) and Maximum
Gain Select (MGS) allow for the best noise performance. The
VCA2616 and VCA2611 also feature low crosstalk and out-
standing distortion performance.
The LNP has differential input and output capability and is
strappable for gains of 5dB, 17dB, 22dB, or 25dB. Low input
impedance is achieved by AT, resulting in as much as a 4.6dB
improvement in noise figure over conventional shunt termina-
tion. The termination value can also be switched to accommo-
date different sources. The output of the LNP is available for
external signal processing.
The variable gain is controlled by an analog voltage whose
gain varies from 0dB to the gain set by the MGS. The ability
to program the variable gain also allows the user to optimize
dynamic range. The VCA input can be switched from the LNP
to external circuits for different applications. The output can be
used in either a single-ended or differential mode to drive high-
performance Analog-to-Digital (A/D) converters, and is cleanly
limited for optimum overdrive recovery.
The combination of low noise, gain, and gain range program-
mability makes the VCA2616 and VCA2611 versatile building
blocks in a number of applications where noise performance
is critical. The VCA2616 and VCA2611 are available in a
TQFP-48 package.
Input
LNPINP
LNP
Gain
Set
LNPGS1
LNPGS2
LNPGS3
LNPINN
Low Noise
Preamp
5dB to 25dB
Voltage
Controlled
Attenuator
Programmable
Gain Amplifier
24 to 45dB
VCAOUTN
VCAOUTP
LNPOUTP VCAINP SEL
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
All trademarks are the property of their respective owners.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of Texas Instruments
standard warranty. Production processing does not necessarily include
testing of all parameters.
www.ti.com
Copyright © 2002-2004, Texas Instruments Incorporated
|
| |
 
TYPICAL CHARACTERISTICS (Cont.)
www.datashAeteTt4Au=.c+o2m5°C, VDDA = VDDB = VDDR = +5V, load resistance = 500Ω on each output to ground, MGS = 011, LNP = 22dB and fIN = 5MHz, unless otherwise noted.
The input to the preamp (LNP) is single-ended, and the output from the VCA is single-ended, unless otherwise noted. This results in a 6dB reduction in signal
amplitude compared to differential operation.
GAIN vs FREQUENCY
(Pre-Amp)
30
LNA = 25dB
LNA = 22dB
25
GAIN vs FREQUENCY
VCA
(VCACNTL = 0.2V)
5.0
4.0
3.0
20
15
10
5
0
100k
LNA = 17dB
LNA = 5dB
1M 10M
Frequency (Hz)
100M
2.0
1.0
0.0
–1.0
–2.0
MGS = 011
–3.0
–4.0
–5.0
100k
MGS = 111
MGS = 100
MGS = 000
1M 10M
Frequency (Hz)
100M
45
40
35
30
25
20
15
10
5
0
100k
GAIN vs FREQUENCY
VCA
(VCACNTL = 3.0V)
MGS = 111
MGS = 100
MGS = 011
MGS = 000
1M 10M
Frequency (Hz)
100M
60
50
40
30
20
10
0
100k
GAIN vs FREQUENCY
LNA and VCA
(VCACNTL = 3.0V)
LNP = 25dB
LNP = 22dB
LNP = 17dB
LNP = 5dB
1M 10M
Frequency (Hz)
100M
60
50
40
30
20
10
0
100k
GAIN vs FREQUENCY
LNA and VCA
(LNP = 22dB)
VCNTL = 3.0V
VCNTL = 1.6V
VCNTL = 0.2V
1M 10M
Frequency (Hz)
100M
2000
1800
OUTPUT-REFERRED NOISE vs VCACNTL
(LNP = 25dB)
RS= 50Ω
1600
1400
1200
1000
MGS = 111
800
600
400
200 MGS = 011
0
0.2 0.4 0.6 0.8 1.0 1.2 1.4 1.6 1.8 2.0 2.2 2.4 2.6 2.8 3.0
VCACNTL (V)
VCA2616, VCA2611
SBOS234E
www.ti.com
5
Preview 5 Page |
Part DetailsOn this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for VCA2616 electronic component. |
| Information | Total 19 Pages | |
| Link URL | [ Copy URL to Clipboard ] | |
| Download | [ VCA2616.PDF Datasheet ] | |
Share Link :
Electronic Components Distributor
|
An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists. |
| SparkFun Electronics | Allied Electronics | DigiKey Electronics | Arrow Electronics |
| Mouser Electronics | Adafruit | Newark | Chip One Stop |
Featured Datasheets
| Part Number | Description | MFRS |
| VCA2611 | The function is (VCA2611 / VCA2616) Variable-Gain Amplifier. Burr-Brown | |
| VCA2612 | The function is TMDual/ VARIABLE GAIN AMPLIFIER with Low Noise Preamp. Burr-Brown Corporation |  |
| VCA2612 | The function is VCA2612: Dual Variable Gain Amplifier with Low Noise Preamp (Rev. C). Texas Instruments |  |
Semiconductors commonly used in industry:
1N4148 |
BAW56 |
1N5400 |
NE555 | | ||
Quick jump to:
VCA2
1N4
2N2
2SA
2SC
74H
BC
HCF
IRF
KA | ||