|
|
Número de pieza | TS2411 | |
Descripción | Tong Ringer | |
Fabricantes | TSC | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de TS2411 (archivo pdf) en la parte inferior de esta página. Total 6 Páginas | ||
No Preview Available ! TS2411
Tong Ringer
Pin assignment:
1. Vcc 5. Gnd
2. Rsl 6. Hfo
3. Lfi 7. Hfi
4. Lfo 8. Out
Operating Voltage 13 to 36V
Ringing Start Voltage 36V (max.)
General Description
The TS2411 is a bipolar integrated circuit designed for telephone bell replacement.
Features
Ordering Information
Designed for Telephone Bell Replacement
Low Current Drain
Adjustable 2-frequency Tone
Part No.
TS2411CD
TS2411CS
Adjustable Warbling Rate
Extension Tone Ringer Modules
Alarms or Other Alerting Devices
Adjustable for Reduced Supply Initiation Current.www.DataSheet4U.com
Built-in hysteresis prevents false triggering and rotary
dial ‘Chirps’
Operating Temp.
-20 ~ +70 oC
Block Diagram
Package
DIP-8
SOP-8
TS2411
1-6 2004/09 rev. B
1 page Application Note
Pin 2 allows connection of an external resistor RSL, which is used to program the solpe of the supply current vs
supply voltage characteristics (see Fig2), and hence the supply current up to the initiation voltage ( VSI ). This
initiation voltage remains constant independent of RSL.
The supply current drawn prior to triggering varies inversely with RSL, decreasing for increasing value of
resistance. Thus, increasing the value of RSL will decrease the amount of AC ringing current required to trigger the
device. As such, longer sucribser loops are possible since less voltage is dropped per unit length of loop wire due to
the lower current level. RSL can also be used to compensated for smaller AC couplin capacitors (C5 on Fig 3)
(higher impedance) to the line which can be used to alter the ringer equivalence number of a tone ringer circuit.
The graph in Fig2 illustrates the variation of supply current with supply voltage. Three curves are drawn to show
the variation of initiation current with RSL. Curve B( RSL=6.8KW) shows the I-V characteristic for the TS2411 tone
ringer.
Curve A is a plot with RSL<6.8KW and shows an increase in the current drawn up to the initiation voltage VSI. The
I-V characteristic after initiation remains unchanged. Curve C illustrates the effect of increasing RSL above 6.8KW
initiation current decreases but again current after triggering is unchanged.
Characteristics Curve
Figure 4.
Figure 5.
TS2411
5-6 2004/09 rev. B
5 Page |
Páginas | Total 6 Páginas | |
PDF Descargar | [ Datasheet TS2411.PDF ] |
Número de pieza | Descripción | Fabricantes |
TS2411 | Tong Ringer | TSC |
TS2418 | Telephone tone ringer | TSC |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |