|
|
Número de pieza | DAC0800LCN | |
Descripción | 8-Bit Digital-to-Analog Converters | |
Fabricantes | National Semiconductor | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de DAC0800LCN (archivo pdf) en la parte inferior de esta página. Total 11 Páginas | ||
No Preview Available ! June 1999
DAC0800/DAC0802
8-Bit Digital-to-Analog Converters
General Description
The DAC0800 series are monolithic 8-bit high-speed
current-output digital-to-analog converters (DAC) featuring
typical settling times of 100 ns. When used as a multiplying
DAC, monotonic performance over a 40 to 1 reference cur-
rent range is possible. The DAC0800 series also features
high compliance complementary current outputs to allow dif-
ferential output voltages of 20 Vp-p with simple resistor loads
as shown in Figure 1. The reference-to-full-scale current
matching of better than ±1 LSB eliminates the need for
full-scale trims in most applications while the nonlinearities
of better than ±0.1% over temperature minimizes system er-
ror accumulations.
The noise immune inputs of the DAC0800 series will accept
TTL levels with the logic threshold pin, VLC, grounded.
Changing the VLC potential will allow direct interface to other
logic families. The performance and characteristics of the
device are essentially unchanged over the full ±4.5V to
±18V power supply range; power dissipation is only 33 mW
with ±5V supplies and is independent of the logic input
states.
The DAC0800, DAC0802, DAC0800C and DAC0802C are a
direct replacement for the DAC-08, DAC-08A, DAC-08C,
and DAC-08H, respectively.
Features
n Fast settling output current: 100 ns
n Full scale error: ±1 LSB
n Nonlinearity over temperature: ±0.1%
n Full scale current drift: ±10 ppm/˚C
n High output compliance: −10V to +18V
n Complementary current outputs
n Interface directly with TTL, CMOS, PMOS and others
n 2 quadrant wide range multiplying capability
n Wide power supply range: ±4.5V to ±18V
n Low power consumption: 33 mW at ±5V
n Low cost
Typical Applications
DS005686-1
FIGURE 1. ±20 VP-P Output Digital-to-Analog Converter (Note 5)
Ordering Information
Non-Linearity
Temperature
Order Numbers
Range
J Package (J16A) (Note 1) N Package (N16E) (Note 1) SO Package (M16A)
±0.1% FS
±0.19% FS
±0.19% FS
0˚C ≤ TA ≤ +70˚C
−55˚C ≤ TA ≤ +125˚C
0˚C ≤ TA ≤ +70˚C
DAC0802LCJ
DAC0800LJ
DAC0800LCJ
DAC-08HQ DAC0802LCN
DAC-08Q
DAC-08EQ DAC0800LCN
DAC-08HP
DAC-08EP
DAC0802LCM
DAC0800LCM
Note 1: Devices may be ordered by using either order number.
© 1999 National Semiconductor Corporation DS005686
www.national.com
1 page Typical Performance Characteristics (Continued)
Output Current vs Output
Voltage (Output Voltage
Compliance)
Output Voltage Compliance
vs Temperature
Bit Transfer
Characteristics
DS005686-28
DS005686-29
Power Supply Current
vs +V
Power Supply Current
vs −V
DS005686-30
Note. B1–B8 have identical transfer
characteristics. Bits are fully switched with less
than 1⁄2 LSB error, at less than ±100 mV from
actual threshold. These switching points are
guaranteed to lie between 0.8 and 2V over the
operating temperature range (VLC = 0V).
Power Supply Current
vs Temperature
DS005686-31
Equivalent Circuit
DS005686-32
DS005686-33
FIGURE 2.
5
DS005686-15
www.national.com
5 Page Physical Dimensions inches (millimeters) unless otherwise noted (Continued)
Molded Dual-In-Line Package
Order Numbers DAC0800, DAC0802
NS Package Number N16E
LIFE SUPPORT POLICY
NATIONAL’S PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT
DEVICES OR SYSTEMS WITHOUT THE EXPRESS WRITTEN APPROVAL OF THE PRESIDENT AND GENERAL
COUNSEL OF NATIONAL SEMICONDUCTOR CORPORATION. As used herein:
1. Life support devices or systems are devices or
systems which, (a) are intended for surgical implant
into the body, or (b) support or sustain life, and
whose failure to perform when properly used in
accordance with instructions for use provided in the
labeling, can be reasonably expected to result in a
significant injury to the user.
2. A critical component is any component of a life
support device or system whose failure to perform
can be reasonably expected to cause the failure of
the life support device or system, or to affect its
safety or effectiveness.
National Semiconductor
Corporation
Americas
Tel: 1-800-272-9959
Fax: 1-800-737-7018
Email: [email protected]
www.national.com
National Semiconductor
Europe
Fax: +49 (0) 1 80-530 85 86
Email: [email protected]
Deutsch Tel: +49 (0) 1 80-530 85 85
English Tel: +49 (0) 1 80-532 78 32
Français Tel: +49 (0) 1 80-532 93 58
Italiano Tel: +49 (0) 1 80-534 16 80
National Semiconductor
Asia Pacific Customer
Response Group
Tel: 65-2544466
Fax: 65-2504466
Email: [email protected]
National Semiconductor
Japan Ltd.
Tel: 81-3-5639-7560
Fax: 81-3-5639-7507
National does not assume any responsibility for use of any circuitry described, no circuit patent licenses are implied and National reserves the right at any time without notice to change said circuitry and specifications.
11 Page |
Páginas | Total 11 Páginas | |
PDF Descargar | [ Datasheet DAC0800LCN.PDF ] |
Número de pieza | Descripción | Fabricantes |
DAC0800LCJ | 8-Bit Digital-to-Analog Converters | National Semiconductor |
DAC0800LCM | 8-Bit Digital-to-Analog Converters | National Semiconductor |
DAC0800LCN | 8-Bit Digital-to-Analog Converters | National Semiconductor |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |